IJMEMES logo

International Journal of Mathematical, Engineering and Management Sciences

ISSN: 2455-7749 . Open Access


Wake Formation Flow Physics and Boundary Layer Analysis on the Sides of the Isosceles Triangular Cylinder with Apex Pointing Downstream

Wake Formation Flow Physics and Boundary Layer Analysis on the Sides of the Isosceles Triangular Cylinder with Apex Pointing Downstream

Namit Agrawal
Department of Mechanical Engineering, Graphic Era Deemed to be University, Dehradun, Uttarakhand, India.

Ritvik Dobriyal
Department of Mechanical Engineering, Graphic Era Deemed to be University, Dehradun, Uttarakhand, India.

Maharshi Subhash
Phimach Institute of Learning and Advanced Research, Dhanbad, Jharkhand, India.

DOI https://doi.org/10.33889/IJMEMS.2024.9.2.013

Received on October 01, 2023
  ;
Accepted on January 18, 2024

Abstract

Boundary layer interaction with downstream flow structures was numerically studied to find the region of inactivity behind an 75° isosceles triangular cylinder with apex pointing downstream at intermediate Reynolds numbers (Re = 520, 640, 840 and 1040). The Standard k-ε model in OpenFOAM was used in the study. Numerical results were validated against Particle Image Velocimetry data. Results revealed the stable region of inactivity characterized by low turbulent kinetic energy and vorticity. The onset of secondary vortex and separation point, independent of Reynolds number, was identified. The onset of the secondary vortex was located at (x = 2 mm) from the base and (y = 1.5 mm) from the apex on either side of the cylinder. The ratio of modulus of absolute primary z-component of vorticity, |ω_z^1 |, to the modulus of secondary z-component of vorticity, |ω_z^2 |, was found to be approximately equal to 1.2. This ratio is invariant of the Reynolds number of the study. These findings have practical implications. The unique properties of the inactivity region forms an ideal location that can be used for injecting fluid, placing measurement probe, active flow control and drag reduction. The research problem is formulated in the introduction. Literature is reviewed next providing the background. Details about the range of parameters, governing equations, numerical study details and software used are given in the methodology section. The results section gives the numerical results, verified by mesh refinement test and validated against experimental results. The results are finally discussed in the next section.

Keywords- Boundary layer, Inactivity region, Primary vortex, Secondary vortex, Intermediate Reynolds number.

Citation

Agrawal, N., Dobriyal, R., & Subhash, M. (2024). Wake Formation Flow Physics and Boundary Layer Analysis on the Sides of the Isosceles Triangular Cylinder with Apex Pointing Downstream. International Journal of Mathematical, Engineering and Management Sciences, 9(2), 244-266. https://doi.org/10.33889/IJMEMS.2024.9.2.013.